The photos are after the raft was removed but without any other processing.
The print doesn't use supports and is tested with PLA.
Due to the holes in the legs they can be fragile - the rear left leg on the first print snapped when removing the raft so I've reduced the hole sizes, but take care removing the print anyway.
Some of the thinner parts (wings especially) may be weak.
0.08mm layer height, 6cm tall, 0.4mm nozzle
To be sure it was flat to the print surface I moved it down 0.5mm in the slicer as the hooves seem to be very slightly rounded. I should probably fix the model to have flat hooves instead.