This is Remix of AM8 to be used with Anet A6 or Alunar M506. You will need all the hardware as prescribed in AM8 and will assemble as instructed but replace with these parts. The only difference will be assembling Z motor mounts, which will sit only 4 mm above the bottom aluminum frame. Z stop has smaller properly sized screw holes to mount the stop.
Check for Heat Bed to Y motor clearance if you use the Y motor mount from AM8 design. It will be tight.
Added LED mounts to sit on top of bottom rails.
Added PSU power socket mount to go on the back end of frame.
Necessary parts in place of what AM8 has:
AM6_Z_Rod_Holder_Bearing_R/L (Or no bearing version)
AM6_LCD_Mount (non essential to be exact)
lcd_supports_45_v3 (non essential to be exact)
AM6_Z_Stop (AM8 screw holes are too large)
To reduce warping, try to print the desired flat surface vertically or elevated with supports and on slower speed and lower temps.
PPLA from Hatch Box resists warping.