Loading
dktosoch

Raspberry PI case for B+/2 & 3 Vers. 2.1

by dktosoch Jun 22, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

Waste of time, it has corners filled inside with a ridiculously tight fit for a PI, the corners will simply not get In unless you drill it out.

If you are going to do some electronics prototyping and use a ribbon cable to a breadboard you will have problems because the connector is bigger than the opening for the pins. Also the end cap must be turned 180 degrees as notes on other comments. It is a very tight fit. End up not using the small end piece. Have to use tweezers to extract the SD card.

The third 10mm heatsink doesn't fit into the case. It could be used for voltage regulator there over the parts between the micro usb port and display connector (not HDMI). The min. height of the space available has to be the same as the height of the ethernet connector.

Very nice case. As good as anything you'd buy on Ebay. I did have a problem with the end cap printing. But I flipped it over 180 degrees onto the other side and then mirrored it and it turned out perfect. I also turned off the skirt. Thank you dktosoch!

Thanks for the tip - had to do the same thing. After the flip and adjustment - printed perfectly

Comments deleted.

Hi, question, do you have a version that doesn't have the big slot on top for the connetors? Would like to have that closed.

This is a great case; thanks!

do you have to print it with supports?

It is NOT need to Make support.

are you printing it standing on the shorter side? or laying on the greater side?

I am printing stand up like the stl is maked.

okay, super, makes sense. this is why you don't need supports.

Nice case, the only flaw I found is there is no slot for the camera ribbon cable.