This is a minimalist wallet design that utilizes a generic silicone wristband to hold together the two 3D printed pieces of the wallet. You can place approx. 1-10 cards in the holder as well as some cash on the outside of the wallet under the silicone band.
Please note: The length of the wallet holder is a little bit longer than the cards themselves. The reason being is that the wallet had to be long enough so that a standard silicone band would be tight enough to hold at least one card.
Note: This part file is digitally watermarked. Verify watermarks at https://www.watermark3d.com
Size: 4" x 2.125" x 0.1" (101.6 mm x 53.975 mm x 2.54 mm)
This design fits a standard 0.5" wide silicone band.
With the settings mentioned above, (using Simplify 3D) it will take just over an hour and a half to print one piece and just over three hours for both pieces.