PLEASE NOTE: IF YOU HAVE BEEN REDIRECTED HERE FROM ALIEXPRESS OR ANY OTHER VENDOR OF THESE PRODUCTS OTHER THAN http://www.precisionpiezo.co.uk PLEASE BE AWARE THAT THEIR CLONES OF OUR PRODUCT ARE LESS LIKELY TO WORK, WILL NOT BE SUPPORTED BY US AND BUYING THEM WILL REDUCE OUR ABILITY TO DESIGN NEW PRODUCTS FOR THE REPRAP COMMUNITY.
PLEASE MAKE ONE YOURSELF OR BUY GENUINE.
Update 18-08-17 a 27mm piezo version has been made by m1n1m - many thanks.
Precision Piezo and Moriquendi present a solution for piezo z probing using titan and titan aero hotends/extruders.
Print the bracket in ABS (mouse ears are included for adhesion cut them off afterwards).
Bond using superglue (cyanoacrylate) a 20mm piezo disc, brass side down towards the bracket, into the recess in the base. Please use 2-4 drops of glue, on the underside of the disc only, preferably keeping it to the front and back of the disc to allow the disc to bend with the bracket. Do not over-glue it! Attach to a piezo probing board such as available at http://www.precisionpiezo.co.uk.
This has been tested but we are calling it beta for now, please feed back to us at http://forums.reprap.org/read.php?1,767998,page=5 with any improvements.
You might want to alter the mounting holes in the base to suit your setup.
It should be possible to attach other hotends to this bracket.
The titan mount bracket spacer allows it to work if used upside down, you don't need it if it is orientated as it is shown here.