Loading
E-Mat

Linear bearing blocks (8mm) for brass bushings (Anet A8, A6 and others)

by E-Mat Jun 27, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

Thanks for sharing your holders. I use german bushings, which measure exactly 12.0 mm. I you find the time, could you please add this size, too? Thank you!

Nice you're the only only one with these holders.
I printed a couple of these in PLA and ABS, upwards and sideways, 11mm and 10mm.
But only 1 seemed to grip on to the bushings, because my printer made a print error and made 4 thicker layers where the screwholes are.
Can I request to make the holes of the 11mm Y version a little bit smaller? Let's say 10.9mm or 10.8mm?

I added some more sizes, including the ones you requested. However, if your bushing really is 11.0mm outer diameter then you shouldn´t need any less than 11mm unless your printer´s calibration is off. The 11.5mm version was a tight fit for the 11mm bushings I used.

Thank you, and yes I should take a better look at my printer. It's always a bit fiddly with how the filament gets pushed in. Perhaps my e-steps per mm are off...
Anyway cheers mate.

Interesting! Can you recommend a source or part number for the bushings that you used?