Loading
jwilson484

Filament Clip, Filament Keeper, Filament Holder

by jwilson484 Jun 30, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

a litle loose on one of my spools but works fine on the other good job

I have uploaded a "SmallFilamentClip.stl" file which is the same clip but with a smaller opening, so it should fit more tightly on the spool. Let me know how it works.

Thanks, I have found that if it is a little loose, you can take a lighter and gently heat up the top corner of the clip by holding it in the blue part of the flame for just a second or two and then apply pressure by squeezing the two ends together to close the gap and make it fit tighter. But be careful, because it doesn't take but a second for PLA to heat up enough to be malleable. And as always, be carful not to burn yourself. I may try and remake it so the gap is smaller but I'm new to this and it took me several hours to finally figure out how to use TinkerCAD to make this clip. Ha! The learning curve is steep.

Comments deleted.