Update 7 / 27-jun-19: I've added a reduced printing time version of the housings, based on the remix made by ram64. It's in the separate .zip file. (Reduced Print time.zip)
Also, the STEP files of the initial files were moved into a separate .zip file.
Update 6 / 21-oct-17: added 2 new versions of 2x2 drawers.
Update 5 / 14-jul-17: added a couple of new configurations and vertical fillets to the backs of the drawers. the stoppers should prevent drawers from being pulled out of housings accidentally but at the same time should leave enough room to make it possible on purpose.
Update 4 / 10-jul-17: the family is growing :) added 1x2 and 2x2 sized sets. these have a slightly thicker walls.
Update 3 / 06-jul-17: the 2x1 version is back, this time the dimensions are correct and drawer stoppers are bigger now.
Update 2 / 06-jul-17: the 2x1 version is currently taken down as it won't stack with 1x1... it's a design flaw.
Update 1 / 05-jul-17: added mini tweezers which fit inside the drawers and can be helpful if you don't have your metal ones at hand ;) designing Tweezers was a part of the "Designing for 3D Printing in Fusion 360" course by Vladimir Mariano on Udemy: https://www.udemy.com/designing-for-3d-printing-with-fusion-360/ . I just scaled them down a bit ;)
05-jul17: Initial upload
Mini Drawers Ultimate by zeropage scaled about 150%.
Mini drawers ultimate were too small for me and scaling them up didn't work well so I designed a bigger version. They are scaled up about 150% in all axis.
All of them have magnet slots (8x3 neodymium magnets should work - I'm not sure as I'm awaiting delivery).
These ARE NOT compatible with Mini Drawers Ultimate by zeropage, dimensions differ slightly.
It's still a work in progress as I make minor changes and tweaks here and there ;)
I'd really appreciate any feedback :)
Material I've used: PETG
Nozzle diameter: 0,4 mm
Extrusion width manual: 0,45 mm
Layer height: 0,25 mm
Top/bottom solid layers: 3
Infill: 0% . Prusa i3 handles bridges very well but if you run into issues with housing back wall (there's a small gap to bridge), you may increase housing infill to 5-10%.
Designed from scratch using Fusion 360 with zeropage's design as a sample.