Loading
PapaJohn88

BLTouch Auto Bed Leveling Sensor Mount

by PapaJohn88 Jul 14, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

Hi,
I printed this and don't know how to use it now.
A lot of filing was needed to make them slide easily. But now I'm stuck - not the sliders ;-)

It would be great if you could explain/show:

  • how the long screw is attached (how many nuts? Three or just one?)
  • and/or how the adjustment mechanism works.

edit: I just posted a make showing what I've tried so far.
It didn't felt right and so I tried to remove the screw (it was too long anyway).

Thanks,
Manuel

How did you wire the bltouch up? I have the hictop i3 also and it has the MKP v1 board and I'm not sure how to wire up the servo wires.

I am using a RAMPS board set. I am sure Antclabs could provide a wiring diagram.

Just looked it up on their site and I think what they have will work for me.

I have a quick question, I haven't not yet printed the parts yet but u have two m4 bolts that hold the part to the bearing block. Then u have the other part that slides up and down within that and that part holds the bltouch. By the looks of it the m3x30 goes through the top of the part that is bolted to the block and it threads into the part that is attached to the bltouch? Or does the bolt go all the way through and there is a nut of the bottom side of the part that holds the bltouch?

Hey, I'm printing this right now and my BLTouch comes in today. Is there anything special software wise I need to edit? Like a config.h file? I think I saw a different wiring required.