I created a simple, custom-sized remote control holder for:
- Aeotec Z-Wave Minimote
- Roku 3 Remote
- Xfinity Remote
- Vizio TV Remote
- Wiimote Controller
Each slot is sized to fit each particular remote. I also added text labels to each (for fun).
Although it works well, I ended up using the wrong measurement for the Xfinity remote, making its slot (and the entire holder) wider than I'd like. It still works just fine though!
Printed using PLA with 20% infill.
Each remote was measured using a caliper. I stood each one upright on a table and took the widest measurements between the table and 20mm up (since each hole is about 20mm deep). I added a 0.5 - 1.0mm buffer to each measurement so the fit wouldn't be too snug.