Hey joooooooo, iiiiiiit's yaaaaaa boy RC-WINGMAN!
I won't lie to you!
This is the best quad design right now.
You will lough about a Alien, Chameleon or other new shizzl frame once you have build this up.
This will be your final pick.
High END, ends here! And it won't get any better than this!...;)
Don't get fooled about the optics. All that matters is performance! AND....
THAT'S what THIS design is all about!!!
It's a tpu-case for the famous Kingkong Q90 90mm frame.
The configuration is cg balanced and has a Unify Pro.
The weight including battery is around 55-60 grams.
Use a very sharp knife to get rid of the support material. Its a pain to clean this up so take your time.
I used some epoxy to cover the Unify pro against moisture.
If you like this design please check out my youtube channel and give me a like or two ;)
UPDATE 1# 17.08.2017:
I have 30 Lipos on that build and it flys FAAAANTAAAASTIC!!!!
5 crashes no damages except broken propellers.
Range is at least 200 meters on 25mw!
Flight time is 5 Minutes!!!
UPDATE 2# 30.09.2017:
I have 100 Lipos on that build and it flys FAAAANTAAAASTIC!!!!
20 crashes no damages except broken propellers.
UPDATE 3# 08.01.2018:
It had about 200 lipo's after it's nearly half year of service and I lost it in the gras today. :/
Everything went fine until It jumped into failsafe after I lost the connection with my radio on a pitch to 100m. The motors stopped to spin and it was impossible for me to rearm it on it's 4.51 second fall to earth. After it kissed the gras the video connection got lost. I hope to find it tomorrow.
What a exceptional piece of technology.
UPDATE 4# 09.01.2018:
Found the quad 500 meters away from the starting position.
Not a broken Propeller, everything works fine... :)
My youtube channel:
It's designed to work with this components:
- 1103 8000KV or 11000KV motors
- 2035 Racerstar propellers
- FRSky receiver
- tbs-unify pro 5V
- The Kingkong Q90 frame
- cmos micro camera with microphone
- A BEC for the unify and the cmos camera:
- LC Filter for camera and unify pro:
- FC with osd:
- lots of Turnigy Nano-Tech 300mah 2S 35~70C Lipo Pack
- Some 5 minute epoxy
Successfull printed with a Ultimaker 2+
PLEASE DO A QUICK TESTPRINT WITH YOUR PRINTER IF YOU ARE NOT USING A ULTIMAKER 2. Things will come out smaller or bigger on other printers.
Print in TPA with 20% Fill and 0.8mm Wall Thickness.
Use a fine nozzle to save weight.
Mine is about 4gr. If you use a 0.1mm nozzle you can bring this down to 2gram???