I was looking for a nice joy-con grip for using a single joy-con but couldn't find one that fitted my relative small hands. The best one I could find was the "Single Joy-Con Grip" from 3DBotMaker which was too wide for me and made it too hard to reach one of the triggers.
So, I designed one from scratch. This grip comes in an left (-) and right (+) version, this makes the triggers perfectly centered and easy to reach. The thumb-stick and buttons are better positioned than without the grip but not completely centered because your thumbs have a better reach and thus making the position of the triggers more important than the buttons and stick.
Furthermore, every corner or edge is rounded smooth without weird transition between the different radii. There is a "-" and "+" on each of the grips so you know which one is for which joy-con.
You place the side with the "bump" in first and then lower the other side into the grip, it's very very easy.
Print the grip laying on it's back, just like the pictures. No support needed!
- Layer height: 0.05 - 0.2 mm
- Infill: 15 - 100% (Preferred 25%)
- Support: No
- Material: PLA/ABS/PET
- Post printing: None
And as always: Please share a picture or leave a comment after you printed this part, really appreciate it!