This is a "Z height" adjustable mounting bracket for the BLTouch. It is specifically designed for the CR-10 and for those who have not modified the Hot End. It may work for some who have made modifications; you should be able to tell by looking at the photos. It uses the existing Hot End Mounting Bracket screw, so you only need pair of M3 screws and hex nuts.***update. Use nylock nuts or add lock washers or use a dab of loctite. Vibration will cause the regular hex nuts to loosen.
I have printed and modified it several times to ensure everything fits properly. This is V.3 and I am confident of the fit at these print settings. The cap is only for aesthetics and covers M3x8 hardware.
Nothing fancy or showy about this design, but it works. This is thin and light, but sturdy enough to do the job it is designed to do. If you crash your bed, which may happen some day, this should break away and save your BLTouch from being damaged.
About 40 minutes to print at .2 and 80 mm/s print speed.
You will need (2) M3 screws and nuts. I used M3 x 8 with M3 hex.