Small and unobtrusive fan duct for the E3D-v6 hotend, for use with either a 4020 or 5015 radial fan.
I like the fangs, but I find them a bit too big and in the way, so I designed this one that has a similar dual exhaust profile to the 'Radial Fan Fang' by Lion4H.
I have experimented with a few different fans (single/dual 3030, 4040, etc) and exhaust profiles and found this configuration to give the best results.
There are 2 stl's available, for left-handed and right-handed versions, however as of writing this I have only experimented with the right-handed version.
No supports needed, just orient it so the front face is on the build plate (stl's should already be oriented the correct way)
Thanks for looking, hope people find this useful!