Enjoy summer year-round with these sunflowers!
I printed these with a brim, no rafts, and they adhered well to the plate. Scale sizes using your 3D pre-processing software. Vary the stem lengths by rotating the piece to stand upright in your software and then change the z-height while leaving x- and y- dimensions the same. Rotate the stem back down flat to the build plate for easier printing.
I've included leaves with various dimensions.
I assembled the pieces using Plastruct Plastic Weld, which works quite effectively for bonding PLA pieces. If you mix materials, it binds ABS and PLA together as well. The leaves are a little tricky to orient because the faces are not completely flush, but they did stay together without too much trouble.