Tree of life, entwined lovers, cake topper for a Celtic themed wedding. The models were made in Daz3d, the tree and trunk were from this site.
0.2mm layer height with 10% infill for the bottom part, 0.1mm layer height and 30% infill for the middle, same layer height and 100% infill for the branches. Printed with Hatchbox wood pla. S3d said something like 6 hours... 16 hours and a broken glass bed later...
Lots of support clean up and sanding (a couple of my supports didn't stick). My final product was painted and had flowers/moss glued to it as final touches for the wedding cake.