My original design of an 8 leaf (double layer) iris box. It uses a linked mechanism, similar to those expanding sphere toys, which allows it to open to a large diameter. In fact any number of leaves could be used for this type of mechanism and many variations of it could be made. The mechanism utilises printed ridged pins and holes which clip together.
I have since designed many other iris boxes which you can find on my design page: https://www.thingiverse.com/BrienAllison/designs including an improved version of this design: Octo-box V2 https://www.thingiverse.com/thing:3665610.
I also have premium designs which you can find on my MyMiniFactory page: https://www.myminifactory.com/users/Brien%20Allison
The box is 80mm overall in diameter, while the container opening is around 62mm. It is opened by pushing the notches in the top of the box in an anti-clockwise direction.
No supports are required for any of the parts.
The hinges of the mechanism use ridged pins and holes that clip together. The ridges alternate with 0.1mm layer heights, for this reason the parts must be printed with 0.1mm layer heights at the hinge and pin sections. Using adjustable layer heights in your slicer will allow you to print the majority of the parts at a thicker layer height for speed.
The effectiveness however of these hinges may depend on your specific printer and print settings, they shouldn't be either too tight or too loose. You could use contour xy compensation (ideamaker is a free slicer which does this) or alter your flow rate to adjust the fit for the hinges. The tolerance on the hinges is 0.15mm.
'top door 1' is a plain iris leaf for the top of the box while 'top door 2' is an iris leaf with a notch cut out of it for opening the box. I recommend you print at least two of 'top door 2' and arrange them on opposite sides of the box to allow ease of opening. You may add more if you wish e.g. four as in the first printed example or eight in the second.
Step 1 Part Testing
I would recommend printing one upper and lower door with the settings you expect to print the whole model to test them. The hinges on the points of the doors are slightly smaller than the others so don't mix them up when testing them. Some of the hinge sections are quite thin as I focused on compactness, but are suitably strong on my models, using good quality PLA
Step 2 Printing
To make one box you will need to print: 8x 'top door', 8x 'lower door', 8x 'link' and 1x 'container'. No supports are required for the parts.
Step 3 Assembly
You will probably need some pliers or similar to clip the hinges together.
Firstly begin by assembling the iris mechanism (see exploded diagram). It's ideal if the iris is assembled in the partly open position, otherwise it can be very hard to close if assembled in the fully open position and the hinges are still stiff. Then push the link pins into the container (this may require a large amount of force depending on tolerances). Finally clip the links to the bottom iris doors.
Your Octo-Box should now be fully functional! Let me know if you have any questions or difficulties with the design.