Contents
Tags
Design Tools
License




Liked By View All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing TagSummary
This is a base plate for tools. Check out my Magnet Mounting plate Thingy (25mm conduit) to distinguish the magnet holes from the rampa nut holes.
LINK: https://www.thingiverse.com/thing:1675690
There is 0,5mm space between the two part, except for the bottom of the rest pin.
You can use a tool (can't refer to "THE" tool at the moment) to let the magnets stick out a bit, so that the holes on the side allign 100%. The holes on the side allign with the rampa nuts in the mount plate.
The 5 rampa nut holes in the middle are for something like a dual E3D mount like https://www.thingiverse.com/thing:1222291
Upper holes for the ajustment bar are a lineair pattern of 25mm.
Lower holes (4) have the following distance 6,75mm from the middle and the 2 holes on each side are 16,75mm apart from eachother.
(see messy picture)
P.S. will make a tool to push in the magnets and let them stick out 0,4 / 0,3 / 0,2 / 0,1mm