These are some brackets to allow you to attach an Official Raspberry Pi 7-inch touch screen and Raspberry Pi to the front of your Wanhao Duplicator 6 / Monoprice Maker Ultimate.
This is the screen/Raspi enclosure to use:
I also used this screen surround too (You don't have to, it was just my preference):
You'll also need four M3x10 screws to bolt it all together.
I have the USB power for the Raspberry Pi running from a DC-DC step-down converter I installed inside the machine, connected to the 24v output on the main power supply.
I then ran the USB cable supplied with the printer through a hole in the corner of the machine, through the space at the bottom, then looped out the back and plugged into the USB port at the back.
There are clips integrated into the brackets for holding the USB cable neatly.
For the Ethernet connection, I just ran the cable under the machine and looped it up the front.
If you use Wi-Fi, you can do without the Ethernet wire, I just prefer a wired connection.
I've supplied STEP and Rhino 3D (.3dm) files so you can remix and stuff if needed. Just be cool and credit me somehow. :)
Make it high for strength.