Based on LCD's Atari XL Parallel bus cover.
Remodelled in Windows 10 3D Builder.
Removed cutouts on the side, added Atari logo, and adjusted the catches slightly for a tighter fit.
Had to disable retraction to avoid chance of extruder gear eating a hole in the filament while printing the 2 catch towers part of the model.
Printed using Cura 2.6 slicer.
Some easy cleanup required on the "backside" of the print, due to retraction settings.
After printing LCD's XL Parallel Bus cover, which works quite well and is a fairly close copy of the original plastic part, I decided to change a few things to make it look nicer and fit a bit better:
- Remove the "cutouts" from the ends of the part
- Adjust the catches outwards by 0.5mm to get a tighter fit when installed
- Add Atari logo in the middle of the outside of the part
All remodelling was done in 3D Builder.