This is a case for the DE10 Nano board. The case was made for the MiSTer FPGA project.
The remix fits all SDRAM daughter board configuration horizontal and vertical.
The case prints well in PLA. Supports are advised for the SD-Card slot section only (extra STL is provided).
I added a new top shell for the case integrating a spot for a 40x40x10 fan right above the FPGA chip. It helps with cooling and leaves enough room to place a decent heightened heatsink on top of the FPGA.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.