Replacement joystick buttons for the standard Color Computer joysticks. I'm not sure if these will fit the Deluxe joystick model.
After printing you still need to drill out the button stand with a 1/8" drill bit so it'll fit over the "+" peg on the joystick. The "+" pattern in the button stand was an experiment that didn't fit but did make the drilling much easier/safer. Be careful to drill slow and not go too deep!
Line width: 0.4mm
Filament diameter: 1.76mm
Wall count: 2 round
Up skin layer: 6 layer
Down skin layer: 6 layer
Infill rate: 25%
Initial speed: 9mm/s
Outer wall speed: 0mm/s
Inner wall speed: 0mm/s
Extruder temp: 210 deg C
Head bed temp: 0 deg C (no heated bed)
Drill out the center button stand with a 1/8" drill bit so it'll fit over the "+" peg on the joystick switch.
Used 123D Design to create the shapes, exported to 3D STL (yes to merge shapes), then imported into Pango with the above settings.