A bracket to mount the Pearl Throne Thumper into your e-drum rack. Made to fit the Roland "12" rack, pipe diameter 38mm. The mount can be assembled two different ways so that you can mount it to a vertical or horizontal pipe. You need to print 2 of each pieces. About 300g worth of plastic is needed.
- 10 M4 4mm long threaded brass inserts
-6 M4 screws 20mm
-4 M4 screws 30mm
0,5 Nozzle, 3 outlines, 3 bottoms, 3 tops. You need a brim or raft for the long brackets when using ABS. I used a brim of 6 outlines and 2 layers. Without the prints will lift. The amp does not heat up too much so PLA should work also.