Micro Camera Canopy for Micro brushless builds with a 20x20 Flight Controller Stack. Sits on top of the stack and can be secured with M3 Nylon or Stainless steel nuts.
• Fits 20x20mm Flight Controller Stack
• Adjustable angle for both pod and Camera provided full protection in every angle
• Room for VTX03 or similar micro VTX behind camera
• Small cavity above camera for linear antenna or other wires
**Donating a tip allows us to keep releasing designs like this one and making improvements down the road to current designs!
Suggested print material is Nylon Bridge. Soft materials like PLA or TPU can damage the camera on a hard crash. IF you do not have Nylon ABS may work just fine!
Print in two pieces and screw together using the stock camera screws included in with Micro Cam.