After trying several other great ideas on thingiverse this is what I came up with. Its a remix of a few different mounts. I moved the fan to the side because where it was limits printing on the rear of the hot bed. The fan duct now comes down below the heat block and blows directly on the extruded plastic. The fan is very effective this way. I run my fan speed around 50-60% now. Ive been using this setup for the last 6 months or so and I figured I'd share it. Ive included the "Prusa i3 Rework X-Carriage" rear mount I use with this. If you have any questions post them in the comments. If you use this please let me know by sharing a pic. Hope you enjoy it.
Prusa i3 Rework X-CARRIAGE.stl https://www.thingiverse.com/thing:119616
RepRap Champion All Metal V6 Hot End http://amzn.to/2n5ctUQ
Anycubic All Metal Right Hand MK8 Extruder Block http://amzn.to/2F8SETE
I used this mount for the Bowden:
MK8 Bowden Motor Mount http://www.thingiverse.com/thing:2039986
Hatchbox PLA Black: http://amzn.to/2mYlhM5