Consider supporting me by sending me a tip on thingiverse or PayPal.
Make sure to post a make if you print one!
03/09/2017 - First release.
What Is It?
If you are upgrading your Prusa i3 hotend mount or extruder assemnly, you'll need some way of mounting it to your x rods. Theis x-carriage attaches to the x rods using linear bearings. This x-carriage uses the same four hole mounting system that is used on the Prusa I3 rework 1.5 kit and most designs on thingiverse, so you'll need to print off a compatible x-carriage mount.
My Bowden X-Carriage Mount for E3D V6: https://www.thingiverse.com/thing:2023947
This design uses a clamp to hold the bearings in place rather than using flimsy zip ties.
Thanks to Josef Prusa. I took inspiration for this design from the Prusa MK2s x-carriage.