Yet another controlhorn for rc airplanes and other linkages. This is a small control horn ideal for 1"- 2" control surface give or take a little.
The hole is sized to fit the 16 gauge wire (about 1.5mm) I am using for push rods, so the hole may need some adjustment for your application.
Note: I model knowing the limitations of my 3D printer. Its old and has a few minor quirks. In general its accurate but holes especially tend to print out smaller than they are sized in the model. As such I model holes slightly larger to accommodate this. Test print any part and make sure any attached hardware like wire or skewers fit properly before bulk printing.