This is a curved watch stand/charging dock, for the Sony Smartwatch 3 - Compatible with both regular and magnetic cables. Magnetic is ideal.
Inspired by the Nomad watch stand for Apple Watches.
It can be printed as a single piece, or in 2 pieces and glued together. If printed in 2 pieces, the flat sides go down onto the bed, which makes printing very simple. This is the method used in the photos.
Simply attach a magnetic microUSB cable into the hole, and run the cable out of the bottom, and attach the magnetic microUSB connector into the back of the watch.
This could also be used with a regular microUSB cable. A right angle would work best, and a right angle magnetic cable would be ideal.
My magnetic cables are still in Transit, so photos are just using a regular cable.
Angled profile so when its charging, the screen is visible.
Optionally put a piece of rubber or some feet on the bottom for anti-slip, it however is very stable without anything.
I used a little support for holding up the bridge where the microUSB cable goes though. It would be possible for many printers to bridge this without supports though.