A spring loaded throttle is particular usefull when flying a quad(hex)copter. The quadcopter will maintain its altitude when the throttle stick is released
Works ideal in combination with a Naza flight controller when flying in attitude or gps mode.
Print the clip and the spring holder in ABS or PLA
- use a 2.0mm drillbit to enlarge the hole in the clip
- remove the support from the spring holder which is incorporated in the design
Additional parts required:
- 3x rod 1.5mm x 8mm
I use a spring ordered from conrad with dimensions: 20,5 x 5,5 x 0,5 but a slightly smaller diameter spring with 0.3mm wire would be ideal