Contents
Tags
Design Tools
License
Liked By View All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing TagSummary
I designed this object because I had problems with the props hitting the ground at takeoff, since a under sling battery. The object also might help to reduce some vibrations.
It will lift the end of your quad arms by 12mm, which is 2mm more than most neoprene/3m pads. Make sure to not tighten the motor screws too hard.
My succession is, to print this in TPU to not destroy it on a hard landing.
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20% honeycomb
Notes:
Printed in Semiflex, infill was chosen, so that there is some kind of additional support within the landing pads. Depending on your slicer, this may vary.
More from R/C Vehicles
