This is a replacement part to install an 11kg standing gas bottle for mobile homes.
The original broke, and was made of flimsy plastic. This print is shorter than the original part, but a lot thicker.
Disclaimer: This is a prototype, i.e. it's not tested. Use at your own risk! (But the print fits nicely ;) )
Note: It's been holding a full 11kg bottle for about 1000km now, across France, and especially the Belgium motorway. It's still OK ;)
Printed with 5 Perimeters, 2 Bottom Layers, 5 Top Layers.
Those are settings for the first test print. It has not been tested.