Note: the pilot and upgrade cards trays do not work for the second edition of X-Wing.
I am working on it...
Update: Added an additional top tray, for one large ship, and two small ships, as well as slots for an FFG sleeved damage deck holder, and third party-sized template holder.
Update: Added two additional trays, one with open base, and one with closed base, to use in place of, or instead of the Deep Trays. These Deeper Trays will accommodate the X-Wing dice, as well as movement dials, asteroids, etc. - something the deep trays cannot do.
As per the original designs, but with cut-outs to slot the Range 3 ruler into place.
This set-up is now able to hold everything you need to play X-wing at your local game night, or tournament.
As with the original designs, I can modify these to suit your needs, if you cannot do it yourself. Leave a comment with what you want, and I will see what I can do.
Printed on a (mostly) stock 1.0 in non-proprietary PLA, sliced with Simplify3D.
I adjusted the angle of the Y-Axis by 5 degrees, so the print is just skewed from being front on. This prevented long, fragile lines of support, breaking them into shorter pieces, which were both much stronger, and much easier to remove.
Trays should all be printed with supports, so they stack properly.
Tops and Bases do not need supports, but will benefit from a brim, to prevent warping during printing.
When printing with PLA on the da Vinci, I left the door closed while the first layer and brim/ support were printing, then left the door open for the remainder of the print. I was getting significant warping at the corners with the door closed, but this all but vanished when I left the door open.
After removing supports/ brim, go over the model with a set of needle files, to remove any overhanging material, especially around the holes in the open bases.
I was looking for a compact storage solution for taking my X-Wing gear to game nights.
This is actually version 2, with version 1 being a very ugly set of trays, which I will never post here...
The files were originally created in Sketchup Make 2017, exported as STL files, then run through Netfabb to complete the meshes.
This set of trays is designed for use with four small ships. The ideal configuration is one Top, four Cards_and_Tokens, one Tray-Deep (or Tray-Deep-Open, if you want to save some filament, and don't mind the holes), and one Base-Miniature_Storage. You should be able to fit everything you need to play in this set-up, including the larger templates and range rulers.
The cut-outs in the Top work with several different damage deck holders found on Thingiverse, and my latest template stand, which can be found at https://www.thingiverse.com/thing:805721