I made this outrunner motor mount to retrofit my Multiplex EasyStar glider with a brushless motor. It should work as an upgrade from any 29mm inrunner motor to a standard (small size) brushless outrunner motor for any fixed wing. I created the holes to run motor wires and allow airflow through the cylinder. When installed in the craft it should fit snugly but can be secured in place with a couple spots of hot glue.
I printed with a brim (as always) and supports, but if your printer can do small bridges easily then you don't need the supports. Print with the motor mount side down. I printed with Performance PLA at 212 (eSun filament, with 70 heated bed) but it will work fine with regular PLA (my go-to is Hatchbox at 205 and 70 heated bed).
Let me know if you would like this motor mount modified for another diameter of inrunner motor, I am more than happy to do so and only made this to fit my personal craft!
-Adam, Minimalist Ventures
Any other questions or comments you can email us at firstname.lastname@example.org!