Made this to use at the gym. Their treadmill's book/tablet holder is too low.
I needed something to be towards the top of control panel.
Version 2 Screws are easier to print horizontally (stronger IMO than vertical print) and don't need much support.
Two main stands are included. The one with rounded corners may require more post processing to remove support and clean up.
The stand is at 15 degrees angled downward to stay more upright on treadmill.
I can add ones with different angles if anyone wants them.
Used higher infill for clamp than tablet stand.
25% infill for stand
50% infill for clamp
70% infill for screws
Stand was printed on its side to end with vertical lines while in use.
Clamps also printed on their side with support for screw holes.
Screws are modified from G-clamp by Johann517. I don't know how he printed them w/o support. I printed them horizontally for strength.