UPDATE: M5 Hardware version now added. M5 will be in the name of the STL. The other one is for M3 hardware.
Print with flat side down so no support is needed. A brim is recommended to keep mounting face as flat as possible.
Attaches where the stock feet and mounting plate attach. Loosen 4 Cap screws from mounting plate from underneath, wiggle the plate lose and reinstall on top of where it was once mounted. The feet will (theoretically) add some rigidity to the chassis.
Need to purchase:
M3 T-nuts and M3 x 16mm Long Countersunk screws
Squash Balls (Search on Amazon or elsewhere, I used the double yellow dot kind)
Note: I have redesigned this to use M5 T-nuts and hardware, which is what the CR 10 uses stock. I preferred the smaller hardware for this. But if anyone is interested, I will also upload the model that is for the M5 hardware.
The wedge slot is an option for a riser that I will be uploading after I print it to prove it's functionality. in case I decide to raise the printer just high enough to place the control box underneath the printer along with the filament on a sliding drawer. Still deciding on this set up...