This is the official edition of the Donkey Car
It supports the following cars:
- Desert Monster
- LaTrax Prerunner
This is the new version of the donkey. it prints faster and assembles faster than the old version, the downside is that it uses specialty hardware that can be hard to find. It uses "Thread Forming Screws" also sometimes called PT screws. the sizes we use are:
(3) 3mm diameter 10-12mm length for chassis
(8) 2.2mm diameter and 6-8mm for Raspberry Pi and servo driver.
These screws are available at specialty retailers or can be purchased in the Donkey store for $5 shipped. https://squareup.com/store/donkeycar