Remix of Puredeath's original. There is NO changes to the mount. The design of that part is flawless, and works great.
Several changes/improvements to the rocker design:
1) The rocker has been extended and rounded off so that it can be actuated without a key. I know there are mixed opinions on this, but see the video, it's not protruding in an area that I can imagine anything other than a stick pointing straight out of the trail catching on, and it's reverse motion is limited by change #2.
2) Added a dimple and slope to the ESC side of the top portion of the rocker so that it cannot swing in the reverse direction more than ~1mm. This further reduces any possibility of the rocker getting down into a position where it could interfere with undercarriage clearance.
3) Adjusted the thickness of the rocker where it goes through the mount (made it slightly thicker) to reduce side-to-side motion. If it's snug after you print it, make sure you've trimmed off any jaggies at the edges that may have resulted from overhangs or supports.
4) Adjusted the thickness of the rocker where it goes between the body and slider (made it slightly thinner) for better clearance. On some trucks (like mine) the original was too tight here, as the sliders sat just slightly closer to the body.
Demo Video: https://www.youtube.com/watch?v=hXytwF1WSyU
Thanks for looking, and happy trailing!
Anet A8 (highly modified)
No matter what position you print the rocker in, you're going to need supports. It's a small part, so trimming is easy. Don't sweat the supports!