I designed this for the Mars 58-v2 parachute system .
I have gave space on the plate for the parachute , mayday system and a small lightweight battery .
this is a project in progress will post more as i have it .
the parachute system this is designed for can be found at:
Screws needed :
4 m3 x 20
2 m3 x 12
6 m3 lock nuts
i done the plate in 2mm thick carbon fiber but you could easily use 3mm or if 3d printing, print solid and use as fine a layer as your printer will print to make it strong .
3d printing the plate may not be strong enough even at 3mm . if 3d printing with FDM printer you will want to see the post printing instructions bellow .
print clamps solid .
the design is so you can remove the thumb screws and still fold up the typhoon H for storage .
also this design will benefit from the new kickstarter project at :
very useful to deploy parachute .
also provided is the fusion 360 files
as well as step files .
the Bolt pattern for the system can be found here .
NOTE : the 2 slots on the plate close to the end are there for people that 3d print
so that you can run a zip tie through the holes and around the arm of the drone .
this is done as a safety in case the 3d print separates you will not lose your parachute from the drone .
more to come .
the main Kevlar line in the ejection system may need to be remove and tied to the main support of the H frame, if the mounts and plate is made out of 3d print material so there is no force breaking the mount while it is being deployed and separate the craft from the parachute.