A unusual magnet for your refrigerator.
Make it look like it's zipped open with a finger pointing out to a note, you think is important to remember.
I added a movable zip handle to make it look more dynamic (not really zipping)
V01.7: One solid mesh and more flat at the bottom. Tested in Cura and Slis3r
I'm Sander, creator of this 3D Print. And founder of my own 3D Scan & Design service:
Do you love weddings and 3D Printing?
I've opened up a Shapeways shop for 3D printed wedding accessories:
Check out the Wedding 3D shop on Shapeways
A thanks for your interest!
and keep on printing
Print the magnet-lid STL that is bigger than the diameter measurements (mm) of your magnet.
The maximum magnet height is 4mm to fit in the magnet-lid.
After printing you can put your magnet in the lid and glue it in the hole of the zipper on the bottom.
If you got questions, please leave a comment
Tip for printing: