A 3d printable case for the Arduino Spot Welder V3 from malectrics.eu
For more information on the Spot Welder you can also take a look at: https://www.instructables.com/id/DIY-Arduino-Battery-Spot-Welder/
Parts needed in addition to the 3d printed ones:
- 40x40x10mm 12V fan
- 4pcs M3x30 screws
- 6pcs M3 nuts
A detailed assembly instruction is available here:
- enlarged fan mounting tabs to about 11mm, to also fit fans that are not exactley 10mm wide.
The case parts are recommended to be printed with 0.2mm layer height for best quality, but can also be printed with 0.35mm layer height.
The rotary encoder knob should be printed with 0.2mm layer height to fit good.
Supports are only needed at the build plate. The ventilation slots dont need support.