Contents
Tags
License


Liked By View All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.
Print Thing TagSummary
A 3d printable fuse case for ANL fuses. It can be used together with the Arduino Spot Welder V3 Case (https://www.thingiverse.com/thing:2600227) to fully enclose the Arduino Spot Welder V3 from malectrics.eu
A detailed assembly instruction is available here:
https://malectrics.eu/anl-300a-fuse-case-assembly/
For more information on the Spot Welder you can also take a look at: https://www.instructables.com/id/DIY-Arduino-Battery-Spot-Welder/
Parts needed in addition to the 3d printed ones:
- 4pcs M3x25mm screws
- 4pcs M3 nuts
- 2pcs M5 nuts
- 2pcs M5x12mm screws
- 2pcs M5 washers
- 2pcs M5 brass washers
The case parts can be printed with 0.35mm layer height.
For good look it should be printed with 0.2mm layer height.
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
20%
Notes:
Supports are only needed to print the hole and nut pockets more clean. It is also possible to print without support, but then it is more work to clean up the pockets after printing.