This is a remix of my FLSun Cube 45mm Y axis Bushing Holder. I wanted to improve on this by changing to 4 Mounting holes with 32mm separation (28mm wide) for use on the FLSun Cube carriage. Ensure to set the correct filament width when printing. The Bearing will snap into place with a little bit of force before you put the Cable Ties on. Two 2.5mm/w x 1mm/thick Cable Ties are needed
FLSun Cube & ZoneStar P802QR2
PLA should be fine but ABS is recommended because it is so close to the Hot End and if you enclose your printer.