This is the same turnout that has been included in the main track page. I decided to move it to a separate page to keep things more clear.
Main track page: https://www.thingiverse.com/thing:2146361
See video below for building instruction.
Layer height: 0,2mm
Support: Only for swinging track parts (printed upside down)
Hardware needed: None. (no screws or any extra except tools).
Print the swign track assembly STL's, only use the ones that ends with 1 or 2 if you need to print an extra of any of them alone.
Note! This is not said in the video, if the train keeps derailing when running on the turning part of this turnout, it can be due to the gap where the 2 different rails intersects being too narrow. you can increase the bap by cutting away a bit of the straight track, a millimeter at a time until the train can pass without derailing.