On hold a while
Pokemon is property of pokemon company and Netendo company of japan.
Do not use it for commercial propose
In order to intergrate Snap fit joint into model and don't break off, it had to set model vertically to prevent joint pivot axle break off. 0.1 layer resolution highly recommended then apply sanding on model.
Easy to print.
relatively Hard to print mostly tricky
in order to make twin side hair and tail poseable, need to be caution. said hair and tail is tricky and involved extremly small parts especially side hair.
When print the Tail, make sure set one wall such as 0.4 thick and set No infill to make Tail bendable with non plexible material.
When print Hair A, carefull with bed side malformation and when Hair B, will need to offline brim and set layer 0.1mm as possible
Hair B's link is vulnerable to damege. it's attach to hair A is one of Most hardst part in this glacieon for sake of poseable
Please be careful with removing support from parts. it's pointy which could draw blood.
Different scale from other models. supposed to be easier print difficulty but take longer build time costs