Print 4x of the rectangle feet for your chair, you may need to scale a bit.
Remove the included rubber feet, slip on your printed ones, enjoy.
**Note the included ones may be glued on better than mine were.
Some older Revs are in the Zip, and are NOT recommended under normal conditions.
So let’s start with a story.
Back early in 2017 I bought a pair of these:
My friend had the original versions of them, but I didn't feel like spending $150 on a little chair.
So one day while browsing the interwebz, I saw these nice little ones that cost much less, so I bought them and life was great.
Now in Vancouver, we have some great fireworks every summer, and I was like “Awesome! Got chairs, they fit in my backpack, and I can take them on my motorcycle.” So I went down to the waterfront, staked out my spot, and enjoyed the show. BUT the chair kept sinking into the sand. At some point in the night during the readjustment, I somehow lost the included feet. I was kinda pissed, but like, we can fix that.
Not only could I fix that, I could improve the design. As we kept sinking into the sand, I figured I could use the snow shoe method, and create a wider base, have less sink, and replace what I lost.
So here we are. After a few revisions, because the first one was a rush, and the second I couldn’t math. V3 was ok, but V4 is the most refined.