I really enjoyed this Leg Lamp design. I wanted to make it a little easier to print so I removed the base in tinker cad and designed a new base and lamp shade to separate out the parts to utilize different color filaments.
On my i3 clone I printed everything at 130%.
The leg is printed with a brim to increase build plate adhesion. Print it with 0% infill to run a wire. I used 3 perimeter layers and drilled the bottom of the shoe and top of the leg to pass the electrical wire.
There are two lamp shades. Either one should be printed as is. The center of the shade contains a 16mm diameter mount for one 3-led length of 5050 strip LED's. Print the lamp shade with 25% infill or as you see fit for your printer.
The base prints upside down making the entire project not require supports. Print with 25% infill or as you see best fit for your printer.
Edit 12/1/2018 - I uploaded a different base. Prints a bit faster.