Work in progress (Because I'm lazy YOU will need to rotate the STL's to print)
Fits Traxxas Summit or similar 1/10 - 1/8 scale RC
Print in ABS or PETG for strength at 0.2mm (mine were printed at 0.3mm for print speed)
Assembly is straight forward if you follow the pictures.
I have used other designs to either inspire or be included as part of the overall design and look of the finished product.
You will need to cut a relief in the shell for the PAN servo to fit.
Hot glue or M3 bolts can be used to attach to shell. (Glue may allow rig to come off in roll over)
Use Good quality DBL sided tape to hold Camera Pod onto the Pan Disk (works better then Hot Glue)
Extras are included (Shovel, Axe, and rear Battery / electronics Roof Rack)
for lid of electronics box i used a piece of 2mm foam cur to size and rare earth magnets to hold together)
Best to print with raft as most prints have lower pockets that will require supports
All prints shown here were printed in my lowest resolution for speed. 0.3mm
Some minor cleanup required.