Loading
CursedMagician

Printbot LC 50mm Fan Mount

by CursedMagician Jul 13, 2012
Download All Files

Thing Apps Enabled

Please Login to Comment

Took a while for me to figure out how to get my prints to stick to the bed again (abs and pla). I got the fan on max 45% power and bed up at 100 all the time. This on a LC printrbot with kapton tape. I used the circle test print and the tough version of the tweezers from here http://www.thingiverse.com/thing:25587http://www.thingiverse.com/thi... .

cross tweezer
by joo

amazing job! just printed one out for my printrbot + and it snapped on with zero cleanup. Also, thanks for making it parametric. I tweaked the fan size to fit what I had and it worked flawlessly.

Printed clean comes off and goes on fairly easy and still feels secure when its on.

Good work.

thank you. I've been too lazy to make this one myself!

Tried it. On my LC+ I couldn't get it to fit without disassembly. I'm not sure if that was intended but it defeats the "clip" notion of the thing. I ended up tweaking it enough with a pair of pliers that it works but I'll need to print another one for long term duty. I'm going to measure my carriage and post the sizes here. The 50mm hole spacing on the other hand was PERFECT.

Sorry to hear it was problematic for you, It is certainly a tight fit, but My one went on without too much of a struggle. I will take it down now and adjust the design to make the fit easier. :(

Talk about super crazy cooling!

I finally managed to get my PB printing after getting all the belts tightened correctly and the bed levelled etc, I was just too scared to take it apart again to fit yours so thats why I did it this way.