Nintendo Switch Charge and Play Stand - Super Mario

by docvalentine Nov 30, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

This is awesome and a must for me to print. I'm completely new to this 3D printing and have printed about 5 total project, most with supports. I cannot seem to find the sweet touch to remove the support without damaging my print. Are there any recommendations or suggestions I should follow? This seems like (for me anyways) will be a challenge to remove all of the support. BUT I HAVE TO PRINT THIS!!! Thanks for your time.

Well done, keep it up.

this screams to be printed on wood filament.

It's very cool. Many thanks

Will this stand allow charging with the cable that came with the switch? I don't have a switch and I am printing it for a friend so I want to get it right:) This looks like a great design though!

Yes, the charging port is on the bottom of the switch and this is designed with just enough elevation to allow room for the charging cable.

Cool thanks! I have it printing right now

Made one came out good need supports 60degree work best for me

Did you have to use supports? What do you recommend for the infill?

yes, tons of supports. there are lots of overhangs so my printer would definitely not handle this without them. i used 60deg, supports everywhere.

you probably won't get away with supports touching base only because the arms are horizontal and need support.

I don't think much infill is necessary, the switch is not heavy at all. i used 10% and it seems fine