This is a case with cover to hold up to ten 1S 3.7V Lipos (incl. Velcro) as used on the Eachine QX95 micro FPV quad or similar micros. The bottom of the box is split so you can print one green and the other red, powerchord on the red side means empty, green it's charged.
The thing consists of two models which I'd recommend to print seperately to get a consistent color, the "box" and the "top". For each there is a "SINGLE" file - use this if you don't have a multicolor printer and want to print all in one color. The bottom won't be split then and you'll have to mark the sides with something (marker, paint, sticker) yourself.
If you have a Prusa MMU you can make good use of all 4 colors, print the inside green and red and the outside with different colors. Use all files which are NOT labeled "SINGLE" to print the multicolored versions. Also check the print settings I've used to mix colors like signal yellow and black and to have the top cover fit on the box neatly with just a slight resistence.
Prusa3D Slic3r MK2 Multi Material Settings:
- 1st Layer: 0.2, all other 0.15
- Vertical Shells: 1
- Top/Bottom Layers 3
- Quality: all (the box in the pic was without "Avoid crossing Perimeters" and had minor stringing between the spacers)
- Seam Position: rear
- Wipe Tower: per color change: 25mm
- Interface Shells: true
Note: the top will be printed on the surface, place the model on the cleanest part of your bed ;)